Christie Digital Systems CX50, CX67, CX60 user manual Power cord, Attachments

Section 4: Maintenance and Troubleshooting

stops, excessive force, and uneven surfaces may cause the projector and cart combination to overturn.

Lamp ' The projector is designed to operate with a 120W UHP lamp. A lamp that has reached the end of its life or has failed should be replaced with a good lamp as soon as possible.

		WARNING
	Turn off the projector before replacing a lamp. Wait
	approximately 5 minutes to allow the lamp to cool
		before removing.
	The lamp is under great pressure when hot and may
	explode, causing personal injury and/or property damage.
	Always allow the lamp to cool before handling and/or
	powering down and unplugging the projector.
	Use only the lamp specified and supplied by
	CHRISTIE in the Lamp Replacement Kit.
	The lamp operates at a very high temperature and pressure.
	Failure to allow the lamp to sufficiently cool prior to handling
	could result in an explosion causing personal injury and/or
	property damage. Wait at least 5 minutes before unplugging the
	projector. This provides enough time for the internal lamp cooling
	fans to cool the lamp and to automatically shut off. Allow the
	lamp to cool completely before handling.
Power cord	' Only use attachments or accessories recommended by the manufacturer. Use of
and Attachments	others may result in the risk of fire, shock or personal injury.
		WARNING
	Use an appropriately rated AC power cord with the
	projector. The power cord supplied is approved for North
		American use only.
	Do not attempt operation if the AC supply is not within the
		specified voltage and power range.
	Do not allow anything to rest on the power cord. Locate the projector where the
	power cord cannot be abused by persons walking on it or objects rolling over it.
	Operate the projector at the specified voltage. Do not overload power outlets and
	extension cords as this can result in fire or shock hazards.
	The projector is equipped with a three-wire plug having a third (grounding) pin.
	This is a safety feature. If you are unable to insert the plug into the outlet, contact
	an electrician to have the outlet replaced. Do not defeat the safety purpose of the
	grounding-type plug.	NOTE: The power cord supplied with the projector is
	approved for North American use only. An appropriately rated power cord with
	IEC320 type plug is required for European and other countries.

4-2 RPMX/CX50/CX60/CX67 User’s Manual