Projector, Pixel, Position, Test P, Status | Christie Digital Systems CX50

Section 3: Operation

PROJECTOR

Press Projector to access options for communication with a specific projector or all projectors within a network.

All Projectors – You can toggle the setting for this option using the Enter key. Set All Projectors to YES if you have a single stand-alone unit or want to enable broadcast control to multiple projectors in a network. In this case, when you send a command using the IR keypad all projectors will respond.

Projector ID – This option is not selectable when All Projectors is set to YES. When NO is selected, you can choose which projector in the network you want exclusive communication with by entering the two- digit projector ID number.

Refer to 3.7 Using Multiple Projectors for more details.

PIXEL

Press Pixel to access the pixel tracking and pixel phase double slidebar.

Adjust pixel tracking first: use and to increase or decrease the frequency of the pixel sampling clock to correct consistency of the image. For proper phase, use ON and OFF to increase or decrease pixel phase so that any shimmer disappears and the image is stable throughout. See Size and Position for a complete explanation of tracking and phase.

POSITION
Press Position	to move the image using the double slidebar. Use		and
to move the image left or right, use ON and OFF to move the image up or
down.
TEST P
Press Test P	to display one of the available test patterns. Press	Test P	again to
display the next available pattern in the sequence. Press Exit		to stop cycling
through the internal test patterns and return to presentation level.

NOTE: You can also access test patterns from the Diagnostics and Service menu. Select Test Patterns and from the drop down list highlight the test pattern you want to display. Press Enter to select.