Cisco Systems Cisco ASR 9001 Router Port Connection Guidelines, Port Name, Description, MLT3

Chapter 1 Preparing for Installation

Cisco ASR 9001 Router Port Connection Guidelines

Cisco ASR 9001 Router Port Connection Guidelines

This section contains detailed cabling and signal information for all interface and port connections to the RP. It also provides information for Ethernet routing and equipment.

Caution Ports labeled Ethernet, SYNC, CONSOLE, and AUX are safety extra-low voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits.

Note In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default, and can be enabled by a license upgrade.

Figure 1-23shows all the port connections on the front panel of the Cisco ASR 9001 Router.

Figure 1-23	Cisco ASR 9001 Router Front Panel Ports
	1	2	3	4	5	6	7	68	9	332426

1	Service LAN and ToD ports	6	External USB port
2	10MHz and 1PPS ports	7	Eight discrete LED indicators
3	SYNC (BITS/J.211) ports	8	CLUSTER ports
4	CONSOLE and AUX ports	9	Fixed SFP+ ports
5	Management LAN ports

Table 1-2lists the Cisco ASR 9001 Router front panel ports description.

Table 1-2	Cisco ASR 9001 Router Front Panel Ports Description
Port Name		Connector Type	Description
TOD Port		RJ45	Time of Day Input/Output Port along with 1PPS
			Signal. Signal type is RS422.
Service LAN Port (IEEE		RJ45	A 10/100Mbps Ethernet Port for IEEE1588 Grand
1588)			Master Connection through CAT5 cable. Signal type is
			MLT3.
10MHz Connector		SMB	10MHz Input or Output for GPS Synchronization.
			This signal can provide 10MHz output as well from
			Cisco ASR 9001 Router. Signal type is sinusoidal.
		Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

1-21