Cisco Systems ASR 9001-S manual Installing Modules and Cables in the Chassis

C H A P T E R 3

Installing Modules and Cables in the Chassis

This chapter contains the procedures for installing cards and modules into the chassis, after it has been installed in a rack. It also describes how to connect cables to the ports and RP.

•Fixed 4x10-Gigabit Ethernet Ports, page 3-1

•Modular Port Adapters, page 3-2

•Installing and Removing Modular Port Adapters, page 3-8

•Installing and Removing SFP and XFP Modules, page 3-14

•Cable Management, page 3-14

•Connecting Route Processor Cables, page 3-18

•Connecting Power to the Router, page 3-20

•Powering on the Router, page 3-23

Fixed 4x10-Gigabit Ethernet Ports

The Cisco ASR 9001 Router has four integrated 10 GE small form-factor pluggable (SFP+) ports that operate at a rate of 10 Gbps.

Each fixed SFP+ port has an adjacent Link LED visible on the front panel. The Link LED indicates the status of the associated SFP+ port.

Note In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default, and can be enabled by a license upgrade.

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

3-1