Chapter 1 Preparing for Installation

Site Requirement Guidelines

Figure 1-18 AC Power Cord CAB-9K10A-EU

 

Cordset rating: 10A, 250 V

Plug:

Length: 8 ft 2 in. (2.5 m)

 

M2511

 

 

Connector: WS 002

 

332625

Figure 1-19 AC Power Cord SFS-250V-10A-IS

Plug:

EL 212 (SI-32)

Cordset rating: 10 A, 250V

Length: 8 ft 2 in. (2.5 m)

Connector: WS 002

332624

DC Powered Router

Connections to DC power modules are rated at 20 A maximum. The system accepts a nominal input voltage of –48 VDC with an operational tolerance range of –40.5 VDC to –72 VDC. One dedicated, commensurately rated DC power source is required for each power module connection.

Power connections to the each DC power module requires two cables: one source cable and one return cable.

For DC power cables, we recommend that you use 20-A-rated, high-strand-count copper wire cables.

The length of the cables depends on your router location from the source power.

Note DC power cables are not available from Cisco, but they are available from external commercial cable vendors.

You must terminate DC power cables using terminal blocks. The terminal blocks are supplied along with the DC power supply modules from Cisco. The terminal block part number is PC 5/2-STF-7.62 BD:+,- from Phoenix contact.

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

1-17

Page 29
Image 29
Cisco Systems ASR 9001-S manual DC Powered Router, AC Power Cord CAB-9K10A-EU