Cisco Systems ASR 9001-S manual Management LAN Ports Connection Guidelines

Chapter 1 Preparing for Installation

Cisco ASR 9001 Router Port Connection Guidelines

Management LAN Ports Connection Guidelines

The RP has two RJ45 media-dependent interface (MDI) Ethernet management LAN ports: MGT LAN 0 and MGT LAN 1 (Figure 1-23).

These ports are used for IEEE 802.3 10BASE-T (10 Mbps), IEEE 802.3u 100BASE-TX (100 Mbps), or 1000BASE-T (1000 Mbps) Ethernet connections.

The transmission speed of the management LAN ports is not user-configurable. The transmission speed is set through an auto-sensing scheme on the RP; the speed is determined by the network to which that the Ethernet port is connected. The combined total input rate of both MGT LAN 0 and MGT LAN 1 is about 12 Mbps.

Management port characteristics are:

•Maximum transmission unit (MTU) is fixed at 1514 and cannot be configured.

•Flow control is disabled and cannot be configured.

•Input unicast packets with an unknown destination address are filtered and dropped.

•Autonegotiation of port speed (10/100/1000) and duplex (full/half) is supported. Autonegotiation cannot be disabled.

Table 1-5lists the signals used on the Management LAN ports.

Table 1-5	RP Management LAN Port Signals
MGT LAN Port Pin		10Base-T, 100Base-TX Signal	1000Base-T Signal
	1	Transmit+	BI_DA+
	2	Transmit–	BI_DA–
	3	Receive+	BI_DB+
	4	—	BI_DC+
	5	—	BI_DC–
	6	Receive–	BI_DB–
	7	—	BI_DD+
	8	—	BI_DD–

Management LAN Port LED Indicators

The Management LAN connectors have integral LED indicators (Figure 1-24). When lit, these LEDs indicate:

•Green (LINK)—Connection is alive.

•Amber (ACT)—Connection is active.

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

1-24