Cisco Systems ASR 9001-S manual AC Electrical Specifications, DC Electrical Specifications

Appendix A Technical Specifications

AC Electrical Specifications

AC Electrical Specifications

Table A-3	AC Electrical Specifications
Description		Value
Power modules per system		Up to two AC power modules per system
Total AC input power		765 VA (volt-amps) per AC power supply
		(up to two AC power supply modules per system)
Rated input voltage1		100–240 VAC nominal (range: 90 to 264 VAC)
		220–240 VAC (UK)
Rated input line frequency1		50/60 Hz nominal (range: 47 to 63 Hz)
		50/60 Hz (UK)
Input current rating1		15 A maximum at 100 VAC
		13 A maximum at 220 to 240 VRMS (UK)
Source AC service		15 A North America and Japan; 10 A international; 13 A UK
requirement1
Redundancy		Power redundancy requirements vary, based on system configuration
		(number and type of line cards, etc). AC and DC powered systems are
		N+1 protected.

1. For each AC power supply module.

Caution Be sure that the chassis configuration complies with the required power budgets. Failure to properly verify the configuration may result in an unpredictable state if one of the power units fails. Contact your local sales representative for assistance.

DC Electrical Specifications

Table A-4	DC Electrical Specifications
Description		Value
Power modules per system		Up to two DC power modules per system
Total DC input power per		750 W
power module
Rated input voltage per		–48 VDC nominal in North America
power module		–60 VDC nominal in the European Community
		(range: –40.5 to –72 VDC [–75 VDC for 5 ms])
Input current rating1		15 A maximum at –48 VDC nominal
		15 A maximum at –60 VDC nominal

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

A-3