Cisco Systems ASR 903 manual Power Supply Considerations, Preventing ESD Damage

Chapter 2 Preparing for Installation

Safety Guidelines

Power Supply Considerations

Check the power at your site to ensure that you are receiving clean power (free of spikes and noise). Install a power conditioner if necessary.

Warning This equipment is designed for connection to TN and IT power systems. Statement 16

Preventing ESD Damage

Warning This equipment needs to be grounded. Use a green and yellow 6 AWG ground wire to connect the host to earth ground during normal use. Statement 383

Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD can occur when electronic printed circuit cards are improperly handled and can cause complete or intermittent failures. When removing and replacing modules, always follow ESD prevention procedures:

•Ensure that the router chassis is electrically connected to earth ground.

•Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. To channel unwanted ESD voltages safely to ground, connect the clip to an unpainted surface of the chassis frame. To guard against ESD damage and shocks, the wrist strap and cord must operate effectively.

•If no wrist strap is available, ground yourself by touching a metal part of the chassis.

•When installing a component, use any available ejector levers or captive installation screws to properly seat the bus connectors in the backplane or midplane. These devices prevent accidental removal, provide proper grounding for the system, and help to ensure that bus connectors are properly seated.

•When removing a component, use available ejector levers or captive installation screws, if any, to release the bus connectors from the backplane or midplane.

•Handle components by their handles or edges only; do not touch the printed circuit boards or connectors.

•Place a removed component board side up on an antistatic surface or in a static-shielding container. If you plan to return the component to the factory, immediately place it in a static-shielding container.

•Avoid contact between the printed circuit boards and clothing. The wrist strap only protects components from ESD voltages on the body; ESD voltages on clothing can still cause damage.

•Never attempt to remove the printed circuit board from the metal carrier.

Note For the safety of your equipment, periodically check the resistance value of the antistatic wrist strap. It should be between 1 and 10 Mohm.

Cisco ASR 903 Router Hardware Installation Guide

2-8 OL-25178-05