Chapter 3 Installing the Cisco ASR 903 Router

Connecting the Cisco ASR 903 Router to the Network

Figure 3-26 Cisco ASR 903 Router Flash Token Memory Stick

209390

Removing a USB Flash Device

To remove and then replace a USB flash token memory stick from a Cisco ASR 903 Router, follow these steps:

Step 1 Pull the memory stick from the USB port.

Step 2 To replace a Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM as shown in Figure 3-26 . The Flash memory module can be inserted in only one way, and can be inserted or removed regardless of whether the router is powered up or not.

Note You can insert or remove the memory stick whether the router is powered on or not.

This completes the USB Flash memory installation procedure.

Connecting Timing Cables

The following sections describe how to connect timing cables to the Cisco ASR 903 Router:

Connecting Cables to the BITS Interface, page 3-39

Connecting Cables to a GPS Interface, page 3-41

Note When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling sufficient to allow for fan tray removal.

Connecting Cables to the BITS Interface

The following steps describe how to connect a cable to the router BITS port:

Step 1 Confirm that the router is powered off.

Step 2 Connect one end of the cable to the BITS port using a straight-through, shielded RJ48C-to-RJ48C cable.

 

 

Cisco ASR 903 Router Hardware Installation Guide

 

 

 

 

 

 

OL-25178-05

 

 

3-39

 

 

 

 

 

Page 95
Image 95
Cisco Systems ASR 903 manual Connecting Timing Cables, Removing a USB Flash Device, Connecting Cables to the Bits Interface