Chapter 3 Installing the Cisco ASR 903 Router
RSP Installation
Step 3 Pull the fan tray backward toward you no more than 1 inch to disengage it from the power receptacle on the midplane, as shown in Figure
Figure 3-15 Fan Tray Removal
|
|
| SYNC |
|
|
| ACT |
|
|
| PWR |
TOD | BITS | MGMT | STAT |
|
| ENET |
|
|
| 28A |
FAN TEMP
CRIT MAJ MIN
ALARM
209394
Warning When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the fan blades completely stop before you remove the fan tray. Statement 258
Step 4 Wait at least 5 seconds to allow the fans to stop spinning. Then, pull the fan tray backward toward you and out of the chassis.
Note As the fan tray slides out of the chassis, support the bottom of the fan tray with one hand and keep your other hand on the fan tray handle.
This completes the steps for removing the fan tray from the chassis.
To install the new fan tray, follow the steps in “Installing the Fan Tray” section on page
RSP Installation
Follow these steps on handling an RSP module in the Cisco ASR 903 Router:
•Installing an RSP Module, page
•Removing an RSP Module, page
•
|
| Cisco ASR 903 Router Hardware Installation Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||
