Cisco Systems ATA186I2ARF manual Call Command Behavior

Chapter 6 Call Commands

Call Command Behavior

Table 6-4 Call Command Behavior (continued)

	Cisco ATA State and its Definition		Summary of Commands (Input Sequence and Actions)
	DIALING: User is entering phone		•	R—Abort dialing, restart dial tone, and revert to PREDIAL state.
	number, which is parsed with the given		•	Invalid phone number—Abort dialing, plays fast-busy, and go to
	dial-plan rules
				WAITHOOK state.
	CONFIG: User configuring a		•	*69—Call Return
	supplementary service in the United		•	#72v#—Forward unconditional to number specified in 'v'l (PacBell use 72#).
	States
			• #73—Cancel any call forwarding (PacBell use 73#).
			• #74v#—Forward on busy to number specified in 'v' (PacBell does not enable
				this service from the phone).
			• #75v#—Forward on no answer to number specified in 'v' (Pac Bell does not
				enable this service from the phone).
			• *67—CLIR in the next call (if global profile is CLIP)
			• *82—CLIP for the next call (if global user profile is CLIR)
			• *70—Disable call waiting in the next call.
			• *99—Enable Fax Mode in the next call (non-standard).
			• Dial-tone—Revert to PREDIAL state.
			• Any complete configuration sequence—Carry out the configuration
				command, restart dial-tone, and revert to PREDIAL state.
	CONFIG: User configuring a		•	*21*v#—Forward unconditionally to number specified in 'v'.
	supplementary service in Sweden		•	*67*v#—Forward on busy to number specified in 'v'.
			• *61*v#—Forward on no answer to number specified in 'v'.
			• #21#—Cancel any call forwarding.
			• #67#—Cancel any call forwarding.
			• #61#—Cancel any call forwarding.
			• #31#—CLIR in the next call.
			• *31#—CLIR in the next call.
			• *43#—Enable call waiting in the next call (Sweden allows globally disable
				call waiting).
			• #43#—Disable call waiting in the next call.
			•	*69#—Call Return
			• (non-standard)*99#—Enable Fax Mode in the next call (non-standard).
			All Regions:
			• R or any unrecognized sequence—Abort configuration, restart dial tone and
				revert to PREDIAL state.
			• Any complete configuration sequence—Carry out the configuration
				command, restart dial tone, and revert to PREDIAL state.
	CALLING: Phone number is sent;		•	R—Cancel the outgoing call, restarts dial-tone, and revert to PREDIAL
	Cisco ATA is waiting for response from			state.
	the far end
		Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
6-8				OL-3410-01