Cisco Systems ATA186I2ARF manual PaidFeatures, 315

Chapter 5 Parameters and Defaults

Operating Parameters

PaidFeatures

Description

Unsubscribe/subscribe to CallFeatures by setting each corresponding bit to either 0 or 1. The lower 16 bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port. Table 5-3provides definitions of each bit.

Value Type

Bitmap

Default 0xffffffff

	Voice Configuration Menu Access Code
	315
Table 5-3 PaidFeatures Parameter Bit Definitions
Bit Number	Definition
0	Forward unconditionally
1	Forward on busy
2	Forward on no answer
3	CLIP_CLIR
4	Call waiting
5	three-way calling
6	Blind transfer
7	Transfer with consultation. This service allows the user to transfer the remote party to a different number by
	first calling that number and consulting with the callee.
8	Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display
	device attached to the FXS line.
9	Call return
10	Message waiting indication
11	Call Waiting Caller ID. This is available only if the Method bit in CallerIdMethod is set to Bellcore (FSK).

15Fax mode. This service allows the user to set the Cisco ATA to Fax mode on a per-call basis. For Fax mode, use the following settings:

•G.711 codec only

•No silence suppression

•No FAX tone detection

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)

5-24 OL-3410-01