Cisco Systems ATA186I2ARF manual Debugging the Cisco ATA 186/188 Fax Services, Run the command

Chapter 7 Configuring and Debugging Fax Services

Debugging the Cisco ATA 186/188 Fax Services

Configuring the Cisco ATA for Fax Mode on a Per-Call Basis

Note The per-call-basis fax mode feature is only available for the H.323 and SIP protocols.

If you want to activate fax mode on a per-call basis, configure the following parameters:

Procedure

Step 1 CallFeatures and PaidFeatures Bit 15 (for line1—mask 0x8000) and Bit 31 (for line2—mask 0x80000000) = 1: This sets the default to enable fax mode on a per-call basis.

Step 2 AudioMode Bit 2 = 0: This disables fax CED tone detection.

Step 3 CallCmd includes *99;xA (99 is the default; the value can be changed to any prefix code.)

To activate a call from your fax machine, enter *99 (default), then enter the telephone number to which you want to send the fax. The next call will automatically revert to normal mode.

Configuring the Cisco IOS Gateway for Fax Mode

On the Cisco gateway, disable both fax relay and fax pass-through at the dial-peer level or system level with the following commands:

Procedure

Step 1 Run the command:

fax rate disable

Step 2 Run the command:

no modem passthrough

Debugging the Cisco ATA 186/188 Fax Services

This section includes the following debugging topics for fax services:

•Common Problems When Using IOS Gateways, page 7-7

•Using prserv for Diagnosing Fax Problems, page 7-9

•Using rtpcatch for Diagnosing Fax Problems, page 7-12

Common Problems When Using IOS Gateways

Table 7-1lists typical problems and actions that might solve these problems for situations in which the Cisco ATA is using fax over a Cisco IOS gateway.

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)

OL-3410-01 7-7