Set the strip positions before connecting the air pressure line to prevent damage to the equipment. To set the distance the strip stroke moves forward and backward:
1 | Open the mold. |
|
|
2 | Loosen the Forward and Backward Stroke |
| adjustment levers. |
SETTING STRIP POSITIONS
| Backward Stroke | |
Forward Stroke | adjustment lever | |
adjustment plate |
|
|
Backward shock |
| |
|
| |
| absorber |
|
Forward shock |
|
|
Forward Strip | ||
absorber | Stroke adjustment | |
levers
3
Move the Forward Stroke adjustment plate
by hand away from the main arm.
4 Move the main arm to the sprue grip position. 5 Push the Forward Stroke adjustment plate
toward the arm until the forward shock absorber is com- pletely set. Tighten locknut on shock.
6 | Lock the Forward Stroke adjustment levers. |
| This is the Strip Forward position. |
|
|
7 | Move the main arm to the strip back position. |
| Make sure the strip stroke is longer than the distance |
| needed for your application. |
|
|
8 | Lock the Backward Stroke adjustment lever. |
| This is the Strip Backward position. |
|
|
9 | Move the Backward shock absorber forward |
| until it is completely set. Tighten locknut on the shock |
| absorber. |
If you need to adjust the strip stroke any time after installation, always be sure to disconnect and drain the air pres- sure before making the adjustment.
UGR003/0900 | INSTALLATION |
