DXS/DWS 3200 Series User Guide

Defining VLAN Interface Settings

The VLAN Interface Settings Page contains fields for managing ports that are part of a VLAN. The Port Default VLAN ID (PVID) is configured on the VLAN Interface Settings Page. All untagged packets arriving at the device are tagged with the port PVID. To define VLAN interfaces:

1.Click Basic Setup > VLAN > Membership > Interface Settings. The VLAN Interface Settings Page opens.

Figure 75: VLAN Interface Settings Page

The VLAN Interface Settings Page contains the following fields:

Interface — Displays the port number included in the VLAN.

Interface VLAN Mode — Displays the port mode. The possible values are:

General — Indicates the port belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full IEEE802.1q mode).

Access — Indicates a port belongs to a single untagged VLAN. When a port is in Access mode, the packet types which are accepted on the port cannot be designated. Ingress filtering cannot be enabled or disabled on an access port.

Trunk — Indicates the port belongs to VLANs in which all ports are tagged, except for one port that can be untagged.

Customer — Assigns an interface to a VLAN based on the host source MAC address connected to the interface.

Multicast TV VLAN — indicates the CPE VLAN which is mapped to the Multicast TV VLAN.

PVID — Assigns a VLAN ID to untagged packets. The possible values are 1-4094. VLAN 4095 is defined as per standard and industry practice as the Discard VLAN. Packets classified to the Discard VLAN are dropped.

Frame Type — Specifies the packet type accepted on the port. The possible field values are:

Admit Tag Only — Only tagged packets are accepted on the port.

Page 130

Page 131
Image 131
D-Link DWS/DXS-3200 manual Defining Vlan Interface Settings