DXS/DWS 3200 Series User Guide

Unchecked — Maintains the access points.

Remove — Removes access points. The possible field values are:

Checked — Removes the selected access point.

Unchecked — Maintains the current access points.

Adding a New Access point

1.Connect the AP to the switch. The switch discovers the AP.

2.Click . The WTP edit screen opens:

Figure 93: WTP Edit Screen

The WTP Edit screen contains the following fields:

AP Name — Indicates the AP name (Max. 32 alphanumeric symbols)

Anable AP — Enables/Disables the AP

Key — Indicates the WEP encryption key type, the possible field values are:

ASCII — Indicates the WEP key is in ASCII format.

Hex — Indicates the WEP key is in Hex format.

Tunnel Priority — Used to configure the AP priority for VLAN tunneling.

Tunnel Source Enable — Indicates that AP is enabled as a VLAN source via a tunnel.

Enable WAN — Accommodates certain timing constrains in the communication to a remotely connected AP separated by a WAN link or the Internet. To disable WAN support, use the no form of this command..

3.Select the Enable AP check box.

4.Select the key type.

5.Click . The AP is activated.

The WTP Edit Screen is also used for editing existing APs.

Page 152

Page 153
Image 153
D-Link DWS/DXS-3200 manual Adding a New Access point, WTP Edit Screen