D-Link DWS/DXS-3200 manual Booting the Switch, Device Port Default Settings

DXS/DWS 3200 Series User Guide

Device Port Default Settings

The following table describes the device port default settings:.

Table 8: Device Port Default Settings

Function	Default Settings
Port speed and mode	1000M Auto-negotiation
Port forwarding state	Enabled
Head of line blocking	On (Enabled)
prevention
Flow Control	Off
Back Pressure	Off

Note

These default settings can be modified once the device is installed.

The following is an example for changing the port speed on port g1 using CLI commands:

Console(config)# interface ethernet 1

Console(config-if)# speed 100

The following is an example for enabling flow control on port g1 using CLI commands:

Console(config)# interface ethernet 1

Console(config-if)# flowcontrol on

The following is an example for enabling back pressure on port g1 using CLI commands.

Console(config)# interface ethernet 1

Console(config-if)# back-pressure

Booting the Switch

To boot the switch, perform the following:

1.Ensure that the device console is connected to a VT100 terminal device or VT100 terminal emulator.

2.Deactivate the AC power receptacle.

3.Connect the device to the AC receptacle.

4.Activate the AC power receptacle.

When the power is turned on with the local terminal already connected, the switch goes through Power On Self Test (POST). POST runs every time the device is initialized and checks hardware components to determine if the device is fully operational before completely booting. If a critical problem is detected, the program flow stops. If POST passes successfully, a valid executable image is loaded into RAM. POST messages are displayed on the terminal and indicate test success or failure.

Page 32