D-Link DWS/DXS-3200 manual Password Recovery, Wlan Licence Key

DXS/DWS 3200 Series User Guide

Password Recovery

If a password is lost, use the Password Recovery option on the Startup menu. The procedure enables the user to enter the device once without a password.

To recover a lost password for the local terminal only:

1.From the Startup menu, select “4” and press <Enter>. The password is deleted.

2.To ensure device security, reconfigure passwords for applicable management methods.

WLAN Licence Key

To upgrade a DXS- model into a DWS model with WLAN support, the user must enter a Licence key. The following section describes the procedures for entering a Licence Key.

As the switch boots, the bootup test first counts the device memory availability and then continues to boot. The fol- lowing screen is an example of the displayed POST.

------ Performing the Power-On Self Test (POST)	------
UART Channel Loopback Test	PASS
Testing the System SDRAM	PASS
Boot1 Checksum Test	PASS
Boot2 Checksum Test	PASS
Flash Image Validation Test	PASS

BOOT Software Version x.x.x.xx Built 07-Jan-200x 10:53:05

Processor: xxxxxx xxxxx xxxx, xx MByte SDRAM.

I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.

The boot process runs approximately 30 seconds.

The auto-boot message that appears at the end of POST (see the last lines) indicates that no problems were encountered during boot.

To enter a WLAN licence key perform the following:

1.Suspend the startup process by pressing <Esc> or <Enter> within two seconds and the following message is displayed:

Autoboot in 2 seconds -press RETURN or Esc.to abort and enter prom.

The Startup Menu is displayed and contains the following configuration functions:

Startup Menu

[1]Download Software

[2]Erase Flash File

[3]Password Recovery Procedure

[4]Enter Diagnostic Mode

[5]Set Terminal Baud-Rate

[6]Stack menu

[7]License menu

[8]Back

2.From the Startup Menu, press “7”.

Page 48