D-Link DWS/DXS-3200 manual Advanced Configuration, Retrieving an IP Address From a Dhcp Server

DXS/DWS 3200 Series User Guide

console# configure

console(config)# snmp-server community priate rw 10.1.1.1 view bobi

console(config)# exit
console# show snmp
Community-String		Community-Access		View name	IP address
-------------------- ------------------ -------------- ------------
priate		read write		bobi	10.1.1.1
private		read write		bobi	10.1.1.2
Community-String	Group name		IP address		Type
------------------ ------------ ------------------- ------
Traps are enabled.
Authentication-failure trap is enabled.
Version 1,2 notifications
Target Address	Type	Community	Version Udp		Filter To	Retries
				Port name		Sec

---------------- -------- ----------- ---------- ----- ------- ----- ---

------

Version 3 notifications
Target Address	Type	Username Security Udp		Filter	To	Retries
		Level	Port	name		Sec

---------------- -------- ----------- -------- ----- ------- ----- -----

----

System Contact:

System Location:

This completes the initial configuration of the device from a local terminal. The configured parameters enable fur- ther device configuration from any remote location.

Advanced Configuration

This section provides information about dynamic allocation of IP addresses and security management based on the authentication, authorization, and accounting (AAA) mechanism, and includes the following topics:

•Configuring IP Addresses through DHCP

•Configuring IP Addresses through BOOTP

•Security Management and Password Configuration

When configuring/receiving IP addresses through DHCP and BOOTP, the configuration received from these serv- ers includes the IP address, and may include subnet mask and default gateway.

Retrieving an IP Address From a DHCP Server

When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. To retrieve an IP address from a DHCP server, perform the following steps:

1.Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, in order to retrieve the IP address.

2.Enter the following commands to use the selected port for receiving the IP address. In the following example, the commands are based on the port type used for configuration.

–Assigning Dynamic IP Addresses:

console# configure

console(config)# interface ethernet 1 console(config-if)# ip address dhcp hostname <string>

Page 38