D-Link DWS/DXS-3200 manual Site Requirements, Package Contents, Unpacking Essentials

DXS/DWS 3200 Series User Guide

Site Requirements

The device is placed on a table-top. Before installing the unit, verify that the location chosen for installation meets the following site requirements.

•General — Ensure that the power supply is correctly installed.

•Power — The unit is installed within 1.5 m (5 feet) of a grounded, easily accessible outlet 100-250 VAC, 50- 60 Hz.

•Clearance — There is adequate frontal clearance for operator access. Allow clearance for cabling, power connections and ventilation.

•Cabling — The cabling is routed to avoid sources of electrical noise such as radio transmitters, broadcast amplifiers, power lines and fluorescent lighting fixtures.

•Ambient Requirements — The ambient unit operating temperature range is 0 to 40ºC (32 to 104ºF) at a rel- ative humidity of up to 95%, non-condensing. Verify that water or moisture cannot enter the device casing.

Unpacking

This section contains information for unpacking the device, and includes the following topics:

•Package Contents

•Unpacking Essentials

Package Contents

While unpacking the device, ensure that the following items are included:

•The device

•Four rubber feet with adhesive backing

•Rack kit

•An AC power cable

•Console RS-232 cable with DB-9 connector

•Documentation CD

Unpacking Essentials

Note

Before unpacking the device, inspect the package and report any evidence of damage immediately.

To unpack the device perform the following:

1.It is recommended to put on an ESD wrist strap and attach the ESD clip to a metal surface to act as ground. An ESD strap is not supplied with the device.

2.Place the container on a clean flat surface and cut all straps securing the container.

3.Open the container.

4.Carefully remove the device from the container and place it on a secure and clean surface.

5.Remove all packing material.

6.Inspect the product for damage. Report any damage immediately.

If any item is found missing or damaged, please contact your local D-Link reseller for replacement.

Page 26