DCS WOUD-230 Care and cleaning, Removing and replacing the sliding shelves and side racks, Us Ca

US CA

30

Care and cleaning

Removing and replacing the sliding shelves and side racks

1To remove a sliding shelf, grip it by its two front corners (making sure you are gripping the wire shelf and the sliding frame together), tilt upwards and pull it out of the oven.

2	To remove the side racks, gently push the retaining wire from underneath the lock stud, then
	swing the lowest edge of the side rack up and out towards the center of the oven until the rack
	is almost horizontal. The prongs at the top will slide out		Mounting slots
	of the mounting slots.
3	To replace the side racks, hold them almost horizontally
	and locate the prongs into the small mounting slots at the
	top of the oven cavity. While you are doing this, support
	the rack with your hand from underneath, to ensure that
	both prongs perfectly locate into the mounting slots.
4	Lower the side racks carefully and gently place the
	retaining wire underneath the lock stud.	Lock stud
	Important!
		Retaining wire
	Do not lower side racks until the prongs are fully

inserted into the slots so that you do not chip the porcelain enamel.

Manual cleaning and maintenance

Important!

Do not use harsh/abrasive cleaning agents, waxes, scourers, sharp metal scrapers, polishes or commercial oven cleaners to clean your oven, as these will permanently damage the surfaces. If you choose to use a stainless steel cleaner, please read the label to make sure it does not contain chlorine compounds. These are corrosive and may damage your oven’s appearance. Clean the stainless steel surfaces in the same direction as the grain, in a horizontal motion.

Do not clean or use any oven cleaning products on the door seal or cavity seals (gaskets). Do not rub, damage or move the seals, as they ensure that the oven seals properly and thus operates efficiently.

Cleaning the control panel and the stainless steel surfaces

It may be useful to lock the oven controls before cleaning - see ‘How to lock the control panel’ in ‘User preference settings’ for details.

Wipe with a clean damp cloth and dry with a lint-free cloth.

To reduce marks like fingerprints, use a stainless steel cleaner regularly.

Do not use scourers or other abrasive cleaners as they will permanently damage the surface.

Cleaning the exterior surface of the glass door

Use a mild solution of detergent and warm water; use a glass cleaner to remove smears and fingerprints.

Dry with a soft lint-free cloth.

Do not use sharp metal scrapers to clean the oven door glass.

Note: the interior oven door glass will be cleaned during a self-clean cycle.