
Care and cleaning 31 US CA
Cleaning the porcelain enamel surfaces
The oven interior and inner door liners are porcelain enamel and are cleaned during the self- clean cycle.
Cleaning the sliding shelves
Important!
Never leave the sliding shelves in the oven during a
Apply chrome cleaners with a damp sponge or cloth following manufacturer directions. Wipe and dry. For
Cleaning the broil/roast system and side racks
Clean these using a solution of detergent and hot water. They are also dishwasher safe.
Changing the oven light bulbs
The oven is illuminated by three 12 volt/20 watt halogen bulbs. These have a very long life, but if you should need to replace one, use only a replacement bulb purchased from your nearest DCS dealer and follow these steps:
1Allow the oven to cool completely and then turn it off at the wall.
2 | Take out the shelves and side racks (see ‘Removing |
|
| and replacing sliding shelves and side racks’) and |
|
| use a small | Retainer clip |
| the retainer clip at the top of the glass light cover | |
| Plate glass cover | |
| while holding the glass to prevent it falling. The | |
|
| |
| clip pivots counterclockwise (see the diagram). |
|
3 | Carefully lift the glass cover out of the lower |
|
| support and pull out the faulty bulb. |
|
4Holding the replacement bulb in a soft cloth or tissue (touching the bulb will reduce its life span),
insert the new bulb.
5Reposition the glass cover and twist the top clip
back in place. The procedure is the same for the light in the roof of the oven cavity.
Note: oven bulb replacement is not covered by your warranty.