Driver Installation

The Dell™ PowerEdge™ RAID Controller (PERC) H200 and 6Gbps SAS HBA cards require software drivers to operate with Microsoft® Windows®, Red Hat® Enterprise Linux®, and SUSE® Linux operating systems.

This section contains the procedures for installing the drivers for the following operating systems:

Microsoft Windows Server 2003 Server family

Microsoft Windows Server 2008 Server family

Windows Server 2008 R2

Red Hat Linux version 4 Update 7 and later, and version 5 Update 3 and later

SUSE Linux Enterprise Server version 10 Service Pack 2 and later (64-bit only), and version 11 Gold and later (64-bit only)

The three methods for installing a driver that are discussed in this chapter are:

During operating system installation

After adding a new PERC H200 or 6Gbps SAS HBA controller on an existing operating system

Updating existing drivers

NOTE: The Windows Server 2008 R2 operating system includes native support for the PERC H200 card. The driver is automatically installed. For driver updates, see the Dell Support website at support.dell.com.

NOTE: Operating system installation on a RAID 1, RAID 0 or a RAID 10 virtual disk is supported only when the virtual disk is in an optimal state.

NOTE: To ensure you have the latest version of any driver mentioned in this section, check the Dell Support website at support.dell.com. If a newer version exists, you can download the driver to your system.

Driver Installation

31

Page 31
Image 31
Dell H200 manual Driver Installation