Configuration Utility Error Messages
NOTE: These error messages are displayed inside the Configuration Utility. Restart your system and retry if you encounter any of these.
NOTE: If the error message continues to be displayed even after following the steps mentioned in Table
Table
Message | Meaning | Suggested Solution |
|
|
|
An error occurred | An error occurred while | Reseat the controller |
while reading | reading any one of a | and reboot. |
number of settings from |
| |
settings. | the firmware. |
|
|
|
|
An error occurred | Controller setup and | Reboot the system. |
while reading current | initialization has failed. |
|
controller settings. |
|
|
|
|
|
Advanced Device | Failed to read vital | Reflash the firmware |
Properties settings | configuration page from | and reboot. |
not found. | firmware. |
|
|
|
|
Error obtaining | Failed to read vital | Reflash the firmware |
PHY properties | configuration page from | and reboot. |
configuration | firmware. |
|
information. |
|
|
Configuration Utility | Failed to properly read |
Options Image | Configuration Utility |
checksum error. | options from flash. |
Restart and retry. If the issue persists, reflash the firmware on the controller.
Can't load default | Failed to allocate memory |
Configuration | for Configuration Utility |
Utility options. | options structure. |
|
|
An error occurred | An error occurred while |
while writing | writing one or more settings |
to the firmware. | |
settings. |
|
|
|
64
