Dell H200 manual Bios

Table 7-4. BIOS Error Messages (continued)

Message	Meaning
ERROR! Adapter	The adapter did not initialize properly. There may be
Malfunctioning!	a problem with the adapter configuration. Reload the
	BIOS configuration. Invoke the configuration utility
	again and see if the issue persists.
MPT firmware fault	The LSI Logic MPT firmware faulted. Contact Dell.
Adapter removed from	An controller that was previously in the boot order
boot order!	was not found. It has either been removed from the
	system or moved to a different slot.
Updating Adapter	A new adapter was found for which there is no record.
List!	A record will be created for it.
Adapter(s) disabled	An adapter was found, but it has been disabled in the
by user	Configuration Utility and will not be used by the
	BIOS.
Adapter configuration	A controller has been moved or reinstalled in the
may have changed,	system. Add it to the boot order using the available
reconfiguration is	resources.
suggested!
Memory allocation	The controller could not allocate enough memory to
failed	load the Configuration Utility, its strings file, or its
	options file. Reboot the system.
Invalid or corrupt	One of the images for the Configuration Utility,
image	its strings file, or its options file is corrupt. Reload the
	BIOS. Reflash the firmware.
Image upload failed	Could not upload the image for the Configuration
	Utility, its strings file, or its options file. Reload the
	BIOS.Reflash the firmware.
Unable to load the	Could not load the Configuration Utility. This error
Dell PERC H200/HBA	usually follows one of the four previous messages.
Configuration Utility
Dell PERC H200/HBA	<Ctrl><C> is struck with the intention of starting
configuration utility	the configuration utility but insufficient memory is
will load after	available. The configuration utility therefore loads
initialization!	(boot) after POST initialization.

Troubleshooting

67