Updating the Firmware

Updating the Dell™ PowerEdge™ RAID Controller H200 or 6Gbps SAS HBA card firmware package is achieved by flashing the firmware package.

The firmware package can be flashed while the controller is in use.

The system must be restarted for all changes to take effect. If there is a failure while flashing the firmware package (such as a power outage) the controller reverts back to the earlier version of the firmware.

NOTE: If you flash the firmware while using the controller, you may notice temporary degradation in the controller's performance.

Firmware Package Update Utility

Firmware package update utility can be run from a variety of operating systems. This flash is automated and no user intervention is required. You can obtain the firmware package flash utility from the PowerEdge Service and Diagnostic Utilities media that shipped with your system.

You have to perform a manual update. In the event of new firmware package release, check the Dell Support website at support.dell.com for the latest firmware package updates and the firmware package update procedure.

Appendix A: Updating the Firmware

71

Page 71
Image 71
Dell H200 manual Firmware Package Update Utility, Appendix a Updating the Firmware