248 Configuring System Information
–
Disable
— Uses the configuration file as the running configuration only. When the switch reboots,
it will load the configuration from the startup configuration file.
•
Retry Count
— Indicates the number of times to attempt the auto configuration process during boot
up. The number of times the switch has attempted to contact the TFTP server during the current
Auto Configuration session.
•
Auto Configuration State —
Shows the current state of the Auto Configuration process.
Configuring Auto Configuration Using CLI Commands
For information about the CLI commands that perform thi s function, see the
Utility Commands - Auto
Config
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI
commands you use to configure Auto Configuring.
Table 6-52. Auto Configuration Commands
CLI Command Description
boot host auto-save Enables/disables automatically saving the downloaded configuration
on the switch.
boot host dhcp Enables/disables Auto Config on the switch.
boot host retry-count Set the number of attempts to download a configuration.
show boot Displays the current status of the Auto Config process.