Configuring Routing 503
Figure 9-1. ARP Create
The ARP Create page contains the following fields:
•
IP Address
— Enter the IP address you want to add. It must be the IP address of a device on a subnet
attached to one of the switch's existing routing interfaces.
•
MAC Address
— The unicast MAC address of the device. Enter the address as six two-digit
hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
Adding an Entry to the ARP Table
1.
Open the
ARP Create
page.
2.
Specify the addresses to be associated.
3.
Click
Apply Changes
.
The addresses are now in the ARP cache.
Adding Entries to the ARP Table Using CLI Commands
For information about the CLI command that per forms this function, see the following chapter in the
CLI Reference Guide
:
• ARP Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-1. ARP Create Commands
CLI Command Description
arp Creates an Address Resolution Protocol (ARP) entry.
ip proxy-arp Enables proxy ARP on a router interface.