616 Configuring IPv6
•
Router Advertisement NS Interval
— Specifies retransmission time field of router advertisement sent
from the interface. A value of 0 means the interval is not specified for this router. The range of
neighbor solicit interval is 1000 to 4294967295.
•
Router Lifetime Int erval
— Specifies the router advertisement lifetime field sent from the interface.
This value must be greater than or equal to the maximum advertisement interval. 0 means do not use
the router as the default router. The range of router lifetime is 0 to 9000.
•
Router Advertisement Reachable Time
— Specifies the router advertisement time to consider
neighbor reachable after the neighbor discovery (ND ) confirmation. The range of reachable time is 0
to 3600000.
•
Router Advertisement Interval
— Specifies the maximum time allowed between sending router
advertisements from the interface. The default value is 600. the range of maximum advertisement
interval is 4 to 1800.
•
Router Advertisement Managed Config Flag
— Specifies the router advertisement managed address
configuration flag. When true, the end nodes use DHCPv6. When false, the end nodes auto configure
the addresses. The default value of managed flag is Disable.
•
Router Advertisement Other Config Flag
— Specifies the router advertisement other stateful
configuration flag. The default value of other config flag is Disable.
•
Router Advertisement Suppress Flag
— Specifies the router advertisement suppression on an
interface. The default value of suppress flag is Disable.
•
IPv6 Destination Unreachables
— Indicates whether the interface sends (Enabled) or suppresses
(Disabled) ICMPv6 unreachable messages. This field also applies to tunnels.
Configuring IPv6 Interface
1.
Open the
IPv6 Interface Configuration
page.
2.
Modify the fields as needed.
3.
Click
Apply Changes
.
The IPv6 interface modifications are saved, and the device is updated.
Configuring IPv6 Interface with the CLI Commands
For information about the CLI commands that per form this function, see the following chapter in the
CLI Reference Guide
:
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.