Figure 3-7. Removing and Installing an Optical or Tape Drive

2

3

1

4

1

sliding plate

2

IDE data cable to drive

3

power cable to drive

4IDE connector on system board

7If you are installing another drive in the bay, see "Installing an Optical or Tape Drive" on page 49.

8If the drive is being permanently removed, install an insert on front drive bezel. See "Replacing an Insert on the Front Drive Bezel" on page 44.

9Replace the front drive bezel. See "Replacing the Front Drive Bezel" on page 43.

10Close the system. See "Closing the System" on page 41.

11Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.

48

Installing System Components

Page 48
Image 48
Dell SC440 owner manual IDE connector on system board