Dell SC440 owner manual Removing the Power Supply

Power Supply

Removing the Power Supply

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 41.

3Depending on your system configuration, disconnect the following power cables:

•P1 and P2 to the system board

•P3 and P5 to the SATA or SAS drives

•P7 to the diskette drive

•P8, P9, and P10 to the optical and tape drives

NOTE: Note the routing of the DC power cables underneath the tabs in the system frame as you release the tabs and remove the cables from the system board and drives. You must route these cables properly when you replace them to prevent their being pinched or crimped.

4Remove the heat sink and shroud assembly. Loosen the two captive screws holding the heat sink and shroud assembly in place.

These captive screws are adjacent to the processor cooling fan housing. See Figure 3-15.

5Tilt the heat sink and shroud assembly away from the fan housing and lift it out.

6Remove the IDE, I/O panel, and SATA cables (if present) attached to the routing clamps on the side of the power supply.

7Using a #2 Phillips screwdriver, remove the four Phillips screws that secure the power supply to the back panel.

8Press the power-supply release tab down and slide the power supply toward the front of the system, then lift it out of the system chassis. See Figure 3-19.

9Remove the cable clamp and set it aside to attach to the new power supply.

Installing System Components

69