Installing an Optical or Tape Drive
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1Unpack the drive and prepare it for installation. For instructions, see the documentation that accompanied the drive.
If you are installing a SCSI tape drive, you must have a SCSI controller card installed (see "Installing an Expansion Card" on page 78) and configure the tape drive according to the documentation that came with the tape drive.
NOTE: Each device attached to a SCSI host adapter must have a unique SCSI ID number (narrow SCSI devices use IDs 0 to 7; wide SCSI devices use IDs from 0 to 15). Set the drive’s SCSI ID to avoid conflicts with other devices on the SCSI bus. For the default SCSI ID setting, see the documentation provided with the drive.
NOTE: There is no requirement that SCSI ID numbers be assigned sequentially or that devices be attached to the cable in order by ID number.
NOTE: SCSI logic requires that the two devices at opposite ends of a SCSI chain be terminated and that all devices in between be unterminated. Therefore, you enable the tape drive’s termination if it is the last device in a chain of devices (or sole device) connected to the SCSI controller.
2Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
3Open the system. See "Opening the System" on page 57.
4Remove the front bezel. See "Removing the Front Bezel" on page 59.
5If another drive is installed, remove it (see "Removing an Optical or Tape Drive" on page 63) and remove the three shoulder screws to attach to the new drive. See Figure
6If the drive bay is empty, remove the insert on the front bezel. See "Removing Front Bezel Insert" on page 60.
7Remove the two shoulder screws from the EMI filler panel and attach them to the new drive. See Figure
66
