Dell Vostro 1000 owner manual Memory module, Clips 2 per connector

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

3If you are replacing a memory module, remove the existing module:

a Use your fingertips to carefully spread apart the memory-module securing clips on each end of the memory module connector until the module pops up.

b Remove the module from the connector.

1

2

1 memory module	2	memory-module securing
		clips (2 per connector)

4

96

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

Ground yourself and install the new memory module:

aAlign the notch in the module edge connector with the tab in the connector slot.

bSlide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

Adding and Replacing Parts