Using LANVIEW
Enterasys NAC Controller Hardware Installation Guide 5-3
Table 5-1 LANVIEW LEDs
LED Color State Recommended Action
MGMT None Off. This module is NOT the
Management Module.
None.
Green Solid. This module is the
designated Management
Module.
None.
Amber Flashing. This is a temporary
indication that the module is
saving data.
None.
CPU None Power off. Ensure chassis has adequate power.
Amber Blinking. Module in process of
booting.
None.
Solid. Testing. If the LED remains amber for several
minutes, contact Enterasys Networks for
technical support.
Green Blinking. Image starts running. None.
Solid. Functional. None.
Red Solid. Processor in reset. None.
Green
and
Amber
Blinking. Indicates that the
module is in the process of
shutting down.
None. This state is activated when the
OFFLINE/RESET switch is pressed for less
than 1 second to a start the process of an
orderly shutdown.
While in this state, do not remove any
chassis.
Amber
and off
Alternating (67% on, 33% off).
Indicates that a shutdown
process has completed. This
indication will remain for 60
seconds before automatically
restarting.
While in this state, you have 60 seconds to
safely remove the chassis from the chassis.
RX
(Receive)
None No link. No activity. Port
enabled or disabled.
None.
Green Solid. Link present, port
enabled, no traffic is being
received by the interface.
None.
Amber Flashing. Link present, port
enabled, traffic is being received
by the interface.
None.
Red Blinking. Indicates collisions.
This indication is only supported
on 10/100 ports.
Contact Enterasys Networks for technical
support.