Enterasys Networks 2S4082-25-SYS NAC Controller Engine Interface Specifications, Processor/Memory

7C111 Chassis Specifications and Regulatory Compliance

NAC Controller Engine Interface Specifications

Table A‐5 provides the Input/Output ports, processor and memory, physical, and environmental specifications for the NAC Controller Engine (same on both ‐SYS models).

Table A-5 NAC Controller Engine Specifications

Item	Specification
Ports
External Gigabit Ethernet Ports (2)	When referring to these ports with NAC Controller PEP CLI
	commands, use the following syntax to designate port type,
	slot location, and port number:
	ge.1.port#
	where ge is the port type, 1 specifies the the slot location of
	the single-slot NAC Controller PEP within the chassis, and
	port# is the port number. The port # will be designated as
	the next sequential ge port after the last ge port on the NAC
	Controller PEP.
	Mini-GBIC slots can be mix-and-match, 1000BASE-SX, -LX,
	-ELX and 1000BASE-T compliant Minii-GBICs. Refer to
	“Mini-GBIC Input/Output Specifications” on page A-7.
Internal Gigabit Ethernet Ports (2)	The two internal ports connect to the on-board processor
	and are used by the installed NAC Controller Engine
	software. These ports have the same capabilities as any
	other NAC Controller PEP port.
	When referring to these ports with NAC Controller PEP CLI
	commands, use the following syntax to designate port type,
	slot location, and port number:
	pc.1.port#
	where pc is the port type, 1 specifies the the slot location of
	the single-slot NAC Controller PEP within the chassis, and
	port# is the port number, either 1 or 2.
RS 232 Serial COM Port	Provides connection for Local Management. This port may
	be used for NAC Controller initialization.
VGA Port	Provides display monitor connection.
10/100 Ethernet Port	Can be used for NAC Controller initialization, management,
	or network connection.
USB Port	Provides USB connection.
Processor/Memory
Processor	Pentium M 14 GHz Processor
Dynamic Random Access Memory	1 GB
(DRAM)
Hard Drive	60 GB 2.5 inch drive
External Power Supply
AC Input Voltage	100—200V
AC Input Amps	1.5A
Frequency	50-60Hz

Enterasys NAC Controller Hardware Installation Guide A-3