EverFocus EKR-KB1 operating instructions Views, Telemetry mode, Defining the views

5.2.3.2 Telemetry mode

When in Telemetry mode the keyboard can only control telemetry receivers and domes. Any other action (but changing active DVR and selecting a new video channel) is not possible. All numerical keys are used to request a view (views are described in the following paragraph) and the joystick to move pan & tilt heads and domes.

When in Telemetry mode a special screen is proposed:





5.2.4 “Views”

Views can be used to carry out a series of four operations by pressing only one key:

•selection of a new active monitor

•selection of a camera on the new active monitor

•selection of the receiver associated with the camera

•scan operation on a pan & tilt position that is already stored in the receiver.

If the views are set up correctly this will speed up operations by making 10 preset camera/monitor/receiver/scan operations available to the operator.

The use of views is especially useful in alarm situations: if key  is associated with camera 12 (which

usually corresponds to receiver 12), monitor 3 and scan 5, just pressing key will replace the sequence

.

By pressing the key the operator will therefore be able to quickly recall a preset position defined on a monitor.

5.2.4.1 Defining the views

Views are set up by pressing three keys simultaneously, from  to , if the

operator is authorised to set up the views.

The display shows the current setup of the view for about one second, and then passes to the request for new parameters:

































The display in the example illustrated here shows that when key 1 is pressed, this is a request for camera 1 on the active monitor (the  symbol means that no monitor in particular is requested for the operation) and there is no request for a scan for the pan & tilt associated with the camera (the  symbol next to the word ).

Inserting the camera.

Insert a number or press to confirm the previously defined number.

Inserting the monitor.

Insert a number or press to confirm the previously defined

number. If the number 0 is inserted this means the active monitor will not be changed when the view is requested.

Inserting the scan position.

Insert a number or press to confirm the previously defined

number. If the number 0 is inserted this means no scan operation will be requested when the view is requested.

Page 27 MNNCEKRKB1_0439