EverFocus EKR-KB1 operating instructions Baudrate Dip

5.11.2.2 Matrix settings

Inside the matrix, both jumpers JP1 and JP2 should be set up for RS232 type communication, as shown in the drawing.

Dip switch SW1 is used to select the baud rate:

Baudrate	dip 3	dip 4
9600 baud	ON	ON
1200 baud	OFF	ON

Refer to the respective manual for further information.

5.11.2.3 Keyboard settings

While the keyboard is being set up, the submenu should be set as follows:









Control of a SW164OSM matrix.

Even in the presence of more than one keyboard connected to the matrix, the identification number of each keyboard is of no importance.

5.11.2.4 Operational test

If the keyboard is connected directly with the switcher set up in this way using the telephone cable supplied, it should be possible to switch the input videos immediately:

•press to select monitor 1

•press , , to select the cameras.

Page 40 MNNCEKRKB1_0439