EverFocus EKR-KB1 operating instructions Controlling the multiplexer using a video device

5.15 Controlling the multiplexer using a video device

The multiplexer can be controlled using a new generation video device (EKR-8/4, EKR-16/4).

In order to control a multiplexer in this way, the MACRO protocol must be used.

MUX

AUX

V

In this case control may refer equally to the video matrix or the multiplexer. Therefore the choice of active monitor should be made differently in each case.

5.15.1 Selecting a monitor connected to the video matrix

Press , followed by the monitor number and if correct confirm with .

After selecting a monitor the display will show the word , followed by the monitor number.

Only monitors that have been defined as “enabled” in the  menu can be requested.

5.15.2 Selecting a monitor connected to the multiplexer

To each multiplexer corresponds a single main monitor. To use the optional spot monitor see the respective users’ manual..

If the multiplexer is identified by an address (Eneo multiplexer for example), press , followed by the

multiplexer address and if correct confirm with .

If the multiplexer is not identified by an address (a SP16C mux for example) press  and if

correct confirm with .

After selecting a multiplexer the display will show the word , followed by the multiplexer number.

Only multiplexers that have been defined as “enabled” in the  menu can be requested.

Page 48 MNNCEKRKB1_0439