EverFocus EKR-KB1 Receivers associated with the cameras, Requesting the views

5.2.4.2 Requesting the views

Press a key from to to request the corresponding view.

5.2.4.3 Erasing the customised views

Press keys simultaneously.

The default settings for the views can be used to recall cameras 1 to 9 directly without changing the active monitor and without making scans. The recalls camera 10.

5.2.5 Receivers associated with the cameras

To each camera is associated a telemetry receiver.

It is possible for one receiver to be present for each camera and this receiver is assigned permanently at the system installation stage. When the camera-receiver association has been defined it should never be changed unless there are changes to the system itself.

The installation procedure normally expects the assignment of a receiver number corresponding to that of the video input (for example, camera number 10 is controlled by receiver number 10), but the assignment may be more flexible.

Every time a camera has been requested and following this selection a new receiver number is requested, this receiver number will be “remembered” by the keyboard. If requesting a different receiver number from the pre- assigned number is not to be allowed, we advise disabling the setup menu option:



For example:









































Camera 1 has been requested. The display shows that the receiver currently associated with this camera is number 1.

If the operator is authorised to do so, he can assign another receiver number to the camera; if not the display shows an error message.

Camera 2 has been requested, and the display shows that it is currently associated with receiver 2.

Following the new request for camera 1 the last receiver associated with camera 1 is shown.

Page 28 MNNCEKRKB1_0439