EverFocus EKR-KB1 Eneo Fastrax II Dome, Material and reference documents, Setting up the dome

6.7 Eneo Fastrax II Dome

6.7.1 Material and reference documents

Dome Eneo Fastrax II EDC-141

Dome Eneo Fastrax II EDC-161

Dome Eneo Fastrax II EDC-141E

Dome Eneo Fastrax II EDC-142E

Dome Eneo Fastrax II EDC-143E

Fastrax II Protocol and Examples

6.7.2 Connection

6.7.2.1 Cable

White	RS485A	TX +
Yellow	RS485B	TX -

6.7.2.2 Setting up the dome

The dome number should be configured correctly. The protocol should be set as FASTRAX II. The baud rate can be selected between: 2400 (default), 4800, 9600 baud. Consult the dome manual.

6.7.2.3 Setting up the keyboard

While configuring the keyboard, the submenu , should have the following settings:









The baud rate should correspond to the one chosen for the dome.

6.7.3 Configuration

Dome configuration is mostly carried out using the On Screen Menu.

For all dome setup operations the keyboard should be enabled for TELEMETRY CONFIGURATION (menu ).

6.7.3.1 OSM Configuration

Directly connect the dome to the keyboard as shown in the diagram and a monitor to the dome video output. start dome configuration.

The dome shows the on screen menu; the keyboard display shows the mode change:







end of configuration.

Page 73 MNNCEKRKB1_0439