Extron electronic DVS 605 LockIt Bracket Mounting Options, Audio Input Connector Wiring, Figure

5.While holding the connector securely against the lacing bracket, tighten the tie wrap, then remove any excess length.

The LockIt bracket can also be used in a stacked formation, as shown below.

Side Mounted Stacked

Figure 2. LockIt Bracket Mounting Options

DAudio inputs 1-5 (audio models only) — Connect audio sources to these 5-pole captive screw connectors. Wire the connector for line level, balanced or unbalanced, analog stereo as shown below.

Tip

Ring

Sleeves

Tip

Ring

L R

Tip

Sleeve

Tip

Sleeve

L R

Balanced Stereo Input		Unbalanced Stereo Input
Figure 3.	Audio Input Connector Wiring
NOTE:	Control signal ground pins are labeled “G”. Audio ground pins are as .
	The wiring and function are the same, whichever way your product is labeled.

E HDMI output — Connect an HDMI display device to this HDMI connector.

NOTE: All video outputs (HDMI, VGA, SDI) share a common output resolution and display

the same content.

F RGB or HD component (R-Y, Y, B-Y) 15-pin HD video output — Connect an RGB

video display or HD component video display to this HD 15-pin connector.

NOTE: Simultaneous identical scaled outputs for HDMI and analog RGB or HD

component video are available.

G Optional 3G-SDI/HD-SDI output connector — Connect an SDI (serial digital

interface) display to this female BNC connector for SDI output. This complies with

SMPTE 292M and 424M and ITU video digital standards.

NOTE: 3G/HD-SDI output is only active if the current resolution is set to 720p, 1080i,

1080p, or 2k 23.98/24/25 hz.

H Genlock connector and loop through (SDI models only) — Connect an external

reference signal for synchronization of the SDI output. The loop through can be used

to synchronize additional devices.

DVS 605 • Rear Panel Connections 9