Analog Output Format

When a new custom rate has been captured or uploaded, the on-screen display (OSD) dynamically updates with the new rate for that custom slot. For example if a custom 480p EDID is uploaded to slot C1, the LCD would read “C1: 720x480”. These five custom slots are shared between custom output resolutions (based on preferred timings 1 block) and custom EDID tables, which can be assigned to any DVS input.

Analog Output Format

Using either of the Adjust knobs ([ {), select the output video format required by the display: RGBHV (default), RGBS, RGsB, YUV bi-level, and YUV tri-level.

Sync Polarity

Some display devices may require a particular combination of horizontal (H) and vertical

(V)sync signal polarities. Select the appropriate combination of positive or negative H and V sync by rotating either the Adjust horizontal ([) or the Adjust vertical ({) knob.

NOTE: If the output format was specified as RGsB or YUV, or RGBS, this submenu

will not be displayed because this menu is only applicable for RGBHV.

HDMI Format

Using either of the Adjust knobs ([ {), select the HDMI format as follows:

Auto — (based on sink EDID), default

DVI RGB 444

HDMI RGB 444 FULL (0-255, audio, InfoFrames)

HDMI YUV 444 FULL (0-255, audio, InfoFrames)

HDMI YUV 444 LIMT (16-235, audio, InfoFrames)

HDMI YUV 422 FULL (0-255, audio, InfoFrames)

HDMI YUV 422 LIMT (16-235, audio, InfoFrames)

HDCP Notification

The HDCP Notification provides a means of determining if HDCP content restrictions are preventing a video signal from passing. The DVS 605 has the ability to notify the user that they are currently trying to view HDCP protected content through a non-HDCP compliant output port (15-pin HD or 3G/HD-SDI) or a non-HDCP compliant HDMI/DVI display. The options presented to the user during this scenario are the ability to show a green screen with a moving “OSD bug” (see page 32) reading “HDCP CONTENT,” or to disable this message, and instead output muted (black) video on non-HDCP compliant displays.

The HDCP Notification setting can be adjusted via the front panel menu by using either of the Adjust knobs ([ {), to turn HDCP notification on or off.

HDCP CONTENT

Figure 15. Green HDCP Notification Screen

It can also be adjusted via the internal web pages or SIS commands.

DVS 605 • Operation

19

Page 25
Image 25
Extron electronic DVS 605 manual Analog Output Format, Sync Polarity, HDMI Format, HDCP Notification