Extron electronic DVS 605 manual View Comm Settings, Exit Menu, Temperature, Factory Reset

Temperature

This is a read-only menu that gives the internal temperature (degrees C and F) of the connected device. No adjustments can be made.

Factory Reset

This menu allows the user to reset the device to the factory default settings.

Press and hold the Auto-Image button until the display changes. Release and press Auto-Image again to confirm that a reset is desired. The device will be reset.

View Comm Settings

The current RS-232 and IP settings are read-only with this menu. To make any setting adjustments, the “hidden” Edit Comm Settings menu must be accessed (see below).

Press Next to go through each sublevel to view the following: serial port (baud rate and communication type), MAC address (cannot be changed), DHCP status (on or off),

IP address, subnet mask, and gateway address.

NOTE: To enter the “hidden” Edit Comms Settings menu, press and hold in the input

5 and Next buttons simultaneously. The Edit Comms Settings menu appears.

EDIT COMM	Next
SETTINGS
“Hidden” Menu

		Next
SERIAL PORT
9600	RS232

Rotate to change baud rate.

DHCP MODE	Next
<On>

Rotate either to turn DHCP mode On or Off.

I	192.168	Next
P	254.254

Rotate to select octet field. Rotate to change IP address.

Next

S	255.255	Next
M	000.000

Rotate to select octet field. Rotate to change subnet mask address.

G	192.168
W	000.000
	Rotate	to select
	octet field. Rotate
	to change gateway
	address.

Figure 21. Edit Comm Settings Menu

Exit Menu

From this submenu, press the Menu button to return to the User Presets menu cycle, or press the Next button to exit the menu and return to the default cycle.

DVS 605 • Operation 26