Extron electronic manual DVS 605 • SIS Communication and Control

X3^ = HDMI output format:

0 = Auto (based on sink EDID), default

1 = DVI

2 = HDMI 444 RGB (0-255, audio, InfoFrames)

3 = HDMI 444 YUV “FULL” (0-255, audio, InfoFrames)

4 = HDMI 444 YUV “LIMITED” (16-235, audio, InfoFrames) 5 = HDMI 422 YUV “FULL” (0-255, audio, InfoFrames)

6 = HDMI 422 YUV “LIMITED” (16-235, audio, InfoFrames)

X3& = Auto switch mode: 0 = Disable (default)

1 = Gives priority to the highest input

2 = Gives priority to the lowest input

X3* = Audio volume range: -100 dB to 0 dB, in 1.0 dB steps, default = -30 dB (with leading “-”); where 0 = 0 dB (max volume output)

X3( = Audio output format: 1 = Dual mono

2 = Stereo (default)

X4) = Audio gain/Attenuation: -53 through + 09 dB, (with leading “+” or “–“)

X4! = Audio source:

0 = Follow Main window

1 = Follow PIP window

2 = Toggle source

X4@ = Audio input type:

0 = None, input is muted (EDID has no CEA extension)

1 = Analog, 5-pole captive screw (EDID has no CEA extension)

2 = 2Ch digital, embedded in HDMI input, (2Ch PCM audio requested from source via EDID)

3 = Full digital (via EDID to allow any digital audio format from source)

4 = 2Ch digital, Auto (2Ch PCM audio requested from source via EDID), scaler uses embedded digital audio when present, or defaults to the input’s analog 5-pole captive screw

5 = Full digital auto (Full audio is requested from source via EDID). Scaler uses embedded digital audio when present, or defaults to input’s analog 5-pole captive screw.

NOTES: • Inputs 1 and 2 can only be set to X4@ = 0 (all models) or 1 (audio model only).

Attempting to set these inputs to any other format gives an “E14” error message.

• Non-audio models of the DVS 605 will allow X4@ = 0 on inputs 1 and 2, and X4@ = 0, 2, or 3 on inputs 3, 4, and 5.

X4# = Static audio delay, 0 through 255 milliseconds (default is 0)

NOTE: The static audio delay is in addition to the automatic audio delay that is

applied by the DVS 605 to compensate for internal video processing.

X4$ = Video signal status

0 = Video / TMDS signal not detected

1 = Video / TMDS signal detected

X4% = Power save modes

0 = Full power mode (default)

1 = Low power state

X4^ = Screen saver status

0 = Active input detected; timer not running

1 = No active input; timer is running; output sync still active 2 = No active input; timer has expired; output sync disabled

DVS 605 • SIS Communication and Control 39