FARGO electronic HDP600 CR100, HDP600-LC manual Message Cause

RESTRICTED USE ONLY Fargo Electronics, Inc.

Reviewing LCD Messages (continued)

Message	Cause
Check Ribbon Error	The print Ribbon may be jammed,
	not installed properly, broken or
	damaged.

Please clean your	The Printer requires cleaning.
Printer.

Data Excess Error	The print or job data sent to the
OR	Printer is corrupt or has been
	interrupted.
Job Data Error
	Printer has stopped receiving data.

Solution

Verify the Ribbon is installed properly.

∙If jammed, clear it.

∙If broken, repair by taping the Ribbon back on to the take-up core.

Press RESUME to continue or CANCEL to reset the Printer.

For best Printer performance, replace the Cleaning Cartridge Tape’ and clean the Printer s Feed Rollers and Printhead at this time.

Refer to the Maintenance section of your Users Guide for fast easy instructions.

Check the interface cable or cancel the print job and resend.

Press RESUME to continue or CANCEL to reset the Printer.

EEPROM Erased

An error’ was detected in the Printer s EEPROM structure and the EEPROM has been erased.

Enter the factory Print, Encoder and Transfer settings into the LCD. The factory settings are located on the inside of the Printer.

Continued on the next page

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 4-4