FARGO electronic HDP600 CR100, HDP600-LC manual Printing a test

RESTRICTED USE ONLY Fargo Electronics, Inc.

Verifying that your PC can access the Printer using the ping command (continued)

Step

2

3

Procedure

Verify that the PC and the Printer are connected to the same network.

You may be on different subnets of your network and some of the network settings for the Printer are not correct. See your network administrator about this.

(Note: The subnet mask must be the same as other devices on the network and that the unique IP address is part of the network specified by the subnet mask.)

Printing a test page

Step

1

2

Procedure

Try printing a test page from the Printer Driver properties window.

a.Open the Printer Driver properties window.

b.Select Start -> Settings -> Printers and Faxes -> [your Printer Driver name (i.e., DTC400 Card Printer)] -> Properties.

c.Ensure that the printing preferences are set correctly for the Ribbon installed in your Printer.

d.Then select the Print Test page button. See the next section.

If you cannot print a test page, then consider the following:

∙There may be an error at the Printer.

∙There may be a job in the Windows print queue which has stalled.

∙The Printer may be paused or set to operate offline in the Windows print queue.

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 5-59