FARGO electronic HDP600-LC manual Reviewing HDP 600 Series Card Printer Sequence of Operations

RESTRICTED USE ONLY Fargo Electronics, Inc.

Reviewing HDP® 600 Series Card Printer - Sequence of Operations (continued)

Step Process

23

24

The Film/Ribbon Drives and Print Platen Stepper turn ON to advance the printed portion of the Film into position at the heated Lam Roller Stepper Motor, using the Lamination Film Alignment Sensor.

The Headlift Motor engages, moving the Printhead up until the Headlift Sensor is activated. All stop. (Note: This step is not performed after the last Color/Heat Seal Panel is printed.)

25

26

If the heater is not at the required temperature yet, the job will pause.

Stepper engages to move the card to a position directly under the hot Roller. The Top of Form Sensor determines card edge and number of steps to position card. All stop.

27

28

The Headlift Motor turns ON to lower the hot Roller and will stop when the Headlift Sensor is activated. All off.

The Stepper and Film Drive engage to laminate the printed Film onto the card. They will turn off after a given number of steps based on the position given by the card Sensor. All stop. (Note: The Film Encoder is active during this step.)

29

30

31

32

The Headlift Motor turns on to raise the hot Roller, stopping when the Headlift Sensor is activated.

The Film Drive and Stepper turn ON for a given number of clicks based on Film Encoder, until the film is released.

The Stepper turns ON to move the card into the Output Hopper (based on steps from a known position). All stop.

The Heater and Thermocouple are maintained at a set temperature at all times when the Printer is ON. The cooling fan is ON when the Printhead is ON or hot.

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 1-6