FARGO electronic HDP600 CR100, HDP600-LC manual Loading the Overlaminate, Step Procedure

RESTRICTED USE ONLY Fargo Electronics, Inc.

Loading the Overlaminate

(Note: This procedure only applies to the HDP600-LC Laminating Card Printer/Encoder.)

The loading process for both the Thermal Transfer Film and the PolyGuard™ Overlaminate material is the same. Refer to the following steps to load either type of overlaminate into the Printer.

Danger: Do not touch the metal Lamination Shield or the Lamination Roller when loading the overlaminate. These components can become very hot.

Step Procedure

1

2

3

Open the Lamination Module's Top Cover and lift the Lamination Arm.

Remove the overlaminate from its packaging.

Load the overlaminate into the Lamination Module, as shown in the four (4) photos (Displays A to D) in this section.

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 3-16