FARGO electronic HDP600-LC, HDP600 CR100 manual Reviewing LCD Messages

RESTRICTED USE ONLY Fargo Electronics, Inc.

Reviewing LCD Messages (continued)

Message	Cause
Film Sensors are not	Your film Sensors must be
calibrated.	calibrated before the film will align
	properly.
Film is out!	The transfer film has run out.

Transfer film not	The transfer film is not installed or
installed.	it is broken.

Flip Command Error	A flip command was sent to a
	Printer with no Flipper installed.
FPGA Load Fail!	The FPGA is not responding.

Head Temperature	The Printhead is too hot.
Error

Solution

Press CALIBRATE to set them at this time.

Install a new roll of film and press RESUME to continue or CANCEL to reset.

Install the film and press RETRY or press IGNORE to continue with no film installed.

Cancel the print job and send a single-sided print.

Verify that the Lamination Module cable is seated properly.

Allow the Printhead to cool and press RESUME to continue.

If the problem persists, there may be a problem with the temperature Sensor or the Printhead fan.

Call for technical assistance.

Continued on the next page

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 4-6