FARGO electronic HDP600 CR100, HDP600-LC manual Adjusting the Lamination Sensor Calibration

RESTRICTED USE ONLY Fargo Electronics, Inc.

Adjusting the Lamination Sensor Calibration

Step

1

Procedure

Applies only if the Printer is equipped with the Card Lamination Module. (Note: This setting reports the current Lamination Sensor calibration setting as dictated by the Printer Driver's Sensor calibration procedure. In most cases, this will not need to be changed.)

Adjusting the Lamination Temperature Setting

Step

Procedure

1

Applies only if the Printer is equipped with the Card Lamination Module.

Use this setting to change the nominal setting of the Lamination Roller. (Note: In most cases, this will not need to be changed, as more direct control of the Lamination Roller can be achieved through the Printer Driver.)

HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 11-27